Security Level; How To Set Security Level; Date And Time, Format, And Time Zone Settings; How To Update Date And Time Using Internet - Keysight A Series User Manual

System Settings
System Configuration
—
—

Security Level

For security reasons, you can prevent frequency information from appearing on
the FieldFox while in SA, NA, or CAT modes.

How to set Security Level

1. Press System 7 >
2. Then choose from the following:

Date and Time, Format, and Time Zone Settings

Set the local date and time, Date and Time format, and Time Zone that is
shown on the FieldFox screen. The Date and Time is also used to identify files
that are saved.
The Date and Time can also be set by synchronizing with GPS satellites. Learn
more in

How to Update Date and Time using Internet

This method of setting the Date and Time does NOT have the security
restrictions of the other methods (listed below).
This method will NOT set the correct Time Zone. You must do that using the
manual method. See below.
766
Status Line ON OFF Turn ON and OFF the voltage source status line that
appears near the top of the screen. The status line is always ON while
making Voltage Source settings.
Hi Impd. Load ON OFF
current use (Ramp). Default = OFF (Low current (Step)).
System Configuration
— None All frequency settings are visible.
— High Frequency information is blanked from the following:
— Display annotation
— Softkeys
— Marker display and marker table
— Calibration properties
— All settings tables
— Limit line tables
— All saved .png files
— Any of the following will re-display frequency information:
— Set to None, Preset,
"GPS – Distance Settings" on page
Enables/Disables low current use (Step) and high
Security Level
>
Mode Preset, or FieldFox restart.
750.
Keysight N9927-90020 User's Guide