How To Play A Data Log - Keysight A Series User Manual

Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5GTF
Option 377 (CPU2 Only)
How to Use Data Logging (OTA Options 370, 372, and 377)
Learn more, refer to
page

How to Play a Data Log

— Press Measure 1
— If the session is already open, skip the following step. Otherwise:
— Then
If these are large recordings on a device, it could take several seconds for
the FieldFox to display the list.
end of the recording is reached, playback begins again at trace 1 and
continues to loop indefinitely.
During playback, choose from the following:
—
—
Keysight N9927-90020 User's Guide
— Then Back
c. Optional: Press
— Record Indoor Data
refer to Chapter 16
on page 484.
Then choose
Record Data,
Chapter 16
484. See also, Chapter 32, "File Management."
Record Playback
— Then Playback
— Then Recall Log File
——Then Recall File
— Then Play to playback your Table data.
is displayed in the left of screen graticules during playback. When the
Pause Resume Temporarily halts playback. Then choose from the following:
— Pause Resume
Stop Immediately stops playback. Then choose from the following:
— Play Start playback from trace 1.
— Recall Log File Opens a list of stored data files.
Select a file to playback.
— Recall File
— Back
Indoor Map Data Logging
or Recall Indoor Log
Mapping and
Navigate OFF ON,
More
Mapping and "Setting up Data Logging" on
and select a file
Press to continue playing.
then
File. Learn more,
"Setting up Data Logging"
Data Selection, Zoom, Pan,
395