Keysight A Series User Manual page 473

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode
(Option 233 on N991xA), and GPS Receiver (Option 307))
How to Set Up Mapping Settings
3. If you are using an antenna with your measurements, then Connect your
4. Then press Esc >
5. Set up the indoor mapping press
Keysight N9927-90020 User's Guide
equipment similar to Figure 14-1 on page 407
Prototype Phased Array Antenna – Option 360"
page 444 in Chapter 15, "USB Antennas – (Full Capability Requires EMF
Option 358, and SA mode (Option 233 Mixed
Back
only) > Data Logging to view the Data Logging softkeys and set the
Settings, Record Save/Recall, and
Signal Locate.
— For Outdoor Mapping:
System
— Default
— System
folder path/name:
Refer to
— Then File Type
— KML (default) or
— CSV
— Then Save Log File.
or
— Then Recall Log
— Optional Auto Save ON
power loss occurs.
— Then Back
choose
— Press Record Indoor Data
files to select to record a new data log
> Measure 1 or Trace 6 >
More > Indoor Map Data Logging
Record Save/Recall
– Sets the default User Folder path:
——List files (*.csv and *.kml) are save-recalled to:
"[CurrentDevice]:\RecordPlayback\CS\"
——Record-Play files are save-recalled to:
"[CurrentDevice]:\RecordPlayback\CS\"
Or
– Sets the User Folder to the user defined system
——List files are save to-from
"CurrentDevice\<UserSelectedFolder>\"
——Record-Play files are save-recalled to:
"CurrentDevice\<UserSelectedFolder>\"
Chapter 32, "File Management."
File.
(default = OFF). To avoid loss of data, if
More > Indoor Map Data Logging
– opens a menu of previously stored PNG
in Chapter 14, "5G Rapid
or to Figure 15-1 on
Analyzers))".
More (required for OTA
Record
> File Folder Default
or
then
473