Power On; How To Set Power On - Keysight A Series User Manual

Hide thumbs Also See for A Series:

Table of Contents

System Settings

System Configuration

— Static IP Address - Enter the IP Address – including periods - in the format

For all FieldFoxes with firmware ≤A.08.18 and ≤A.09.50 FW, when using

Static IP addresses:

– Either a valid Static Gateway is required or 0.0.0.0.

– Either a valid Static DNS is required or 0.0.0.0. (If entry is available.)

— Static Subnet Mask - Enter the Subnet Mask – including periods - in the

— Static Gateway - Enter the Static Gateway – including periods - in the

— Static DNS - Enter the Static DNS – including periods - in the format

— Apply Settings Choose from:

To make the LAN settings persist after power up, toggle Apply Settings to

Now then back to Power Up. You should see a message indicating that the

LAN config file was saved.

Power ON

When the FieldFox is without a power source, this setting allows the FieldFox

to power ON when the DC Adapter is inserted without pressing the power

1. Press System 7 >

2. Then choose from the following:

Keysight N9927-90020 User's Guide

nnn.nnn.nnn.nnn

format nnn.nnn.nnn.nnn

nnn.nnn.nnn.nnn

— Power Up The above settings take effect when the FieldFox is

— Now The above settings take effect immediately.

when finished.

System Configuration

The FieldFox will power ON when the DC Adapter is inserted.

The FieldFox will power ON only when the power button is

Show Quick Links

Table of Contents