Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode
(Option 233 on N991xA), and GPS Receiver (Option 307))
How to Set Up Mapping Settings
Setting up Data Logging
There are two types of data logging:
"Enabling Outdoor Map Logging" on page 484
"Enabling and Setting Up Indoor Map Logging" on page 487
See also,
"Option 352 Outdoor Maps Setup Procedure" on page
Opening the Data Logging settings:
— Press Measure 1 (Channel Scanner (Option 312) only) or Trace 6 >
Enabling Outdoor Map Logging
If you have already set up your outdoor map logging:
— Then
— Then
— Then
484
"Option 352 Indoor Maps Setup Procedure" on page 472
Logging
Record
to being logging data or
Play
If this softkey is active, you are currently recording or you have
recalled a previously stored data logging file
When Play is pressed, then choose:
—
Cursor Position
the current data log being played (i.e., Cursor Position is active only
when playback is paused).
This softkey is only available in Channel Scanner and Phased Array
Antenna modes (i.e., The Cursor Position softkey is not available for
OTA mode).
—
Maps
– to open a softkey menu enable map view and related
features (e.g., Data Selection, Red/Blue Limits, Labels & Icons,
Zoom). Learn more, refer to step 3.
or
View
(available in Channel Scanner mode and with outdoor mapping
only).
Then choose:
—
Exit
to leave the current View softkey menu and return to the previous
menu.
—
Zoom
use this softkey zoom in/out.
This softkey is only available in Channel Scanner and Phased Array
Antenna modes (i.e., The Cursor Position softkey is not available for
OTA mode).
and
use this softkey to move the data log play cursor in
Keysight N9927-90020 User's Guide
and
476.
Data