Keysight A Series User Manual page 366

Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5GTF
Option 377 (CPU2 Only)
How to Set Up Over–the–Air (OTA) Mode Settings
Learn more about file settings, refer to
13. Outdoor Mapping only: If recording, then:
366
b. Then press Record Save/Recall
— Save Log File
device is Internal). i.e., *.KML or *.CSV (default) files are saved
to the file name and device type. See Settings below and
change Data Logging Configuration settings:" on page 393
— Recall Log File
— File Folder
Default - selects [Internal]:RecordPlayback\OTA
(default) or System - selects [Internal] top of internal
directory.
— Device choose where to store your data files
— File Type
— Auto Save
file (e.g. TempAutoSave.csv) is automatically saved after
each new record is recorded to guard against data lose in the
case of an unexpected shutdown. The temporary log file is
automatically deleted after you stop recording and manually
save the log file.
or
— Back
c. Indoor Map Data Logging
Indoor Log File.
— Then choose
Record Data,
Learn more, refer to Chapter 16
on page 484. See also,
— View Map OFF ON
= latitude/longitude = 0.00/00. Need GPS to view current location
(default = OFF).
— Pause Resume
incoming trace continues to sweep. Press again to continue
recording.
— Stop Immediately stops recording and a "Save the Log File" menu
opens to rename and save your data log file.
To set file settings choose
Chapter 32, "File Management."
to save the current Table data (i.e., default save
select a filename from the list
> CSV or KML choose a file type (Default: CSV)
OFF (default)/ON. When enabled, a temporary log
- then Record Indoor Data
Navigate OFF ON,
More
Mapping and
Chapter 32, "File Management."
To enable/disable the current map view (default
Temporarily halts recording until pressed again. The
Keysight N9927-90020 User's Guide
or Recall
Data Selection, Zoom, Pan,
"Setting up Data Logging"
"To