How To Change The Channel Number Of The Measurement - Keysight A Series User Manual

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
SA Mode Settings
— Then
— Then
With Unit = Chan,
Channel

How to change the Channel Number of the Measurement

With Unit =
of the selected Radio Standard.
— Press Freq/Dist
— Then choose from the following:
Integration BW (IBW) is coupled to the Frequency Span setting. Frequency
Span is 50% wider than the IBW (e.g., if the IBW value is 1 MHz, then the
Frequency Span value is 1.5 MHz).
Select either Uplink or Downlink Frequencies
Press Freq/Dist then More. Press
and Downlink. If either of these selections is not available, then the selected
Radio Standard does not contain those frequencies. In that case,
Direction
Keysight N9927-90020 User's Guide
More
Unit Freq Chan
Channel Direction
Step.
Chan the FieldFox will NOT allow you to specify channels outside
—Center Channel Places the center frequency of the specified channel
in the middle of the X-axis.
—Start Channel Places the lowest frequency of the specified channel at
the beginning of the X-axis.
—Stop Channel Places the highest frequency of the specified channel at
the end of the X-axis.
—Freq Span Changes the span of frequencies while the center frequency
remains unchanged.
—Follow each of the above settings by entering a value using the
numeric keypad or the rotary knob.
—Use the arrows to increment the channel number by an amount
specified by the Channel Step value (see below).
— Then press Enter or Enter.
is grayed out.
becomes available and
Chan Direction to toggle between
CF Step alters to
Uplink
Chan
169