How To Set File Type - Keysight A Series User Manual

File Management
Saving and Recalling Files
Insert only ONE USB Flash Drive in the FieldFox when saving or copying
files.

How to set File Type

— Press Save/Recall 9
— Then
When using RTSA, the Density Spectrum information is not saved using
Trace+State. Only the last displayed trace settings is saved.
Keysight N9927-90020 User's Guide
— USB Saves/Recalls/Moves (Copies) files to or from a USB Flash drive
(not included) that is inserted in one of the USB connectors. Only the
root folder is available.
File Type. Choose one of the following:
— State Saves ALL FieldFox instrument settings for ALL Modes to a
*.sta file. If a calibration is ON in CAT or NA Mode, calibration data is
also saved. This file can be opened ONLY by a FieldFox. State files
can be saved between compatible FieldFox models. See note
in."Saving and Recalling Files" on page
— Trace+State Saves the current trace and instrument settings to a
*.sta file. In SA Mode, all traces are saved. This file can be opened
ONLY by a FieldFox. When recalled, the FieldFox sweep is set to Hold.
— Picture (PNG) Saves a 640 x 453 pixel image of the FieldFox screen to
a *.png file. The picture does NOT include the softkeys.
— Data (csv) Saves trace data from the current Mode to a *.csv file. This
format can be imported into spreadsheet software such as Microsoft
Excel. Column A is always the frequency at which the data is
measured.
——In SA Mode, all visible data traces are saved. Each trace is
saved to a separate column that is labeled with the Trace
State.
——In CAT and NA Modes, only the data trace is saved – not the
memory trace.
——In Power Meter (with Option 208 Frequency Offset Power
Sensor (FOPS)), all visible traces are saved. Each trace is saved
to a separate column labeled Output Power or Memory.
——In VVM Mode, NO data is saved.
778.
785