Option 352 Indoor Maps Setup Procedure - Keysight A Series User Manual

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode
(Option 233 on N991xA), and GPS Receiver (Option 307))
How to Set Up Mapping Settings

Option 352 Indoor Maps Setup Procedure

IMPORTANT!
85571A-028 (28 GHz 5G Phased Array Antenna) accessories not suitable
for use in wet locations.
1. Set up your measurements in Channel Scanner, OTA, or Phased Array
2. Plan your Indoor Map:
Importing floor plans can be imported now or after the indoor map
locations have been measured.
472
Antenna. See also, Chapter 13, "Over–the–Air Measurements (OTA) – LTE
FDD Option 370, LTE TDD Option 371, 5GTF Option 377 (CPU2 Only),"
Chapter 27, "Channel Scanner (Option 312)."
One or more are required:
— For setting up a phased array antenna, refer to
Rapid Prototype Phased Array Antenna – Option 360."
— For setting up a USB antenna, refer to
(Full Capability Requires EMF Option 358, and SA mode (Option 233
Mixed Analyzers))."
Optional:
— For setting up GPS Option 307, refer to
Settings," and then
a. Save mapping pictures to the FieldFox using USB storage device, SD
card, or connect to LAN with internet and download.
b. Import floor plans or site maps to the FieldFox from pictures (PNG,
JPG, and BMP).
Press System 7 >
Import Maps > Import Maps (ZIP)
Optional:
— Press Source Device [Internal]
USB, or CD Drive
— Press Destination Device [Internal]
Card, USB, or
c. Recommended: Do an interactive Walk Test data collection using
the location pointer.
Chapter 15, "USB Antennas –
Chapter 30, "System
"GNSS (GPS+) and GPS" on page
Utilities > Mapping >
– Internal
CD Drive
Keysight N9927-90020 User's Guide
Chapter 14, "5G
758.
Map Explorer (Get Maps)
(default), SD Card,
– Internal (default),
and
>
SD