Right Side Panel - Keysight A Series User Manual

Preparing for Initial Use of Your New FieldFox
Take the FieldFox Tour

Right Side Panel

Connector Description
Ethernet cable connector to read trace data using the FieldFox Data Link
Software and connect to the FieldFox remotely.
Download the latest version of the software at:
www.keysight.com/find/fieldfoxsupport
IF Out used in SA mode for external signal processing.
Frequency Reference Source Output
Trigger Output (ERTA mode).
Secure Digital slot. Use to extend the memory of the FieldFox.
On the N995xA/6xA (Also, applies to: N991xA/2xA/3xA units with serial
number prefixes ≥5607) models, the mini-USB port can be connected to
your PC's standard USB port to send SCPI commands.
Two standard USB connectors used to connect a power sensor for Power
Meter Mode. Also used to save files to a USB flash drive.
52
IMPORTANT! It is recommended that
only USB certified cables are used with
the FieldFox.
IMPORTANT! It is recommended that
only USB certified cables are used with
the FieldFox.
Learn More:
"LAN Settings" on
page 767
"IF Output" on
page 201
Chapter 25, "ERTA
(Extended Range
Transmission Analysis)
Mode - Option 209", on
page 599
"Saving and Recalling
Files" on page 778
Chapter 31, "Using the
Mini-USB Port to send
SCPI Commands and
Queries (N995xA/6xA
and applies to:
N991xA/2xA/3xA units
with serial number
prefixes ≥5607)", on
page 775
"Saving and Recalling
Files" on page 778
Keysight N9927-90020 User's Guide