Power Button Led Status; Fieldfox High Temperature Protection; How To Monitor The Internal Fieldfox Temperature - Keysight A Series User Manual

Preparing for Initial Use of Your New FieldFox

FieldFox High Temperature Protection

— To turn Power OFF (very low battery drain), press the power button briefly
— To restart FieldFox, press the power button and press Restart. See the Note
— Press
— You can also access the power down softkey menu choices (Standby,
— Press Mode
— You can make a setting to automatically Power ON the FieldFox when a

Power Button LED Status

Solid green
Blinking green
Steady amber
Blinking amber and green
Not lit
FieldFox High Temperature Protection
The following features prevent degradation or damage in the event of high
internal temperatures in the FieldFox.
Do NOT store the FieldFox in the soft-case while powered ON or in
Standby mode.

How to monitor the internal FieldFox temperature:

— Press System >
— Then
42
and press the Shutdown softkey. Data and instrument state are NOT
automatically saved when the FieldFox is powered OFF. Learn how to save
data and instrument state in
See the Note above concerning Shut down.
above concerning Restart.
Cancel to exit the power down sequence.
down, Restart, and Cancel) by using the Mode hardkey:
—Then More
—Then Shut down
power source is connected. Learn how on
a
a. Instrument firmware versions dated May/June 2015 and above.
Service
Internal Temperatures.
Chapter 32, "File Management", on page
"Power ON" on page
Power is ON
FieldFox in Stand By mode
The amber LED will remain on after the battery is fully
charged, if the AC adapter remains powered and
connected.
Stand By mode and battery charging
Power is Off and battery is not charging
Diagnostics.
Keysight N9927-90020 User's Guide
777.
Shut
769.