Radio Standard; Attenuation; How To Set Attenuation - Keysight A Series User Manual

Built-in Power Meter Mode – Option 310
Built-in Power Meter Settings

Radio Standard

A Radio Standard can used to integrate power within specific radio channels.
When a Radio Standard is selected, the Span setting is automatically coupled
to the defined Channel Width for that standard. (Width is the same for all
channels within a standard.) Also, Unit is set to Chan, and CF is set to the
nearest specific Channel defined in the standard.
Learn more about Radio Standards, including Importing and Deleting Custom
Radio Standards, beginning in
How to select a Radio Standard
— Press Measure 1 OR Freq/Dist
— Then
— Then select a standard using the

Attenuation

The Attenuation setting controls the power level into the FieldFox.
To compare Built-in Power Meter Mode measurements to SA Channel Power
measurements, use the same attenuation settings. Built-in Power Meter Mode
defaults to 30 dB attenuation, while SA mode defaults to 10 dB attention. In
Built-in Power Meter, the attenuation setting is NOT annotated on the screen.

How to set Attenuation

— Press Scale/Amptd
— Then
— Then
— Then use the
The following Built-in Power Meter settings are identical to the standard
Power Meter settings. To learn about these settings, please refer to the
following pages:
"Scale" on page 549
"Relative and Offset Power Measurements" on page 550
"Display Units" on page 550
"Averaging" on page 551
"Scale" on page 549
"Limits" on page 552
534
Radio Standard
Enter.
More
RF Atten
arrows or rotary knob to choose from either 30 dB or 10
dB
"Custom Radio Standards" on page 168
arrows or rotary knob and press
Keysight N9927-90020 User's Guide