Utilities; How To View And Change Utilities Settings; Utilities Softkey Choices - Keysight A Series User Manual

System Settings

Utilities

Utilities
FieldFox utilities settings will not survive a shut down. When your FieldFox is
turned OFF, then back ON, these settings default to their factory settings.
For information on the Phase Array Antenna and EMF Antennas softkeys,
refer to
360."

How to view and change Utilities Settings

— Press System 7
— Then

Utilities Softkey Choices

Then choose one of the following:
—
—
—
—
736
Chapter 14, "5G Rapid Prototype Phased Array Antenna – Option
and "USB Antennas" an
Utilities Opens the Utilities softkey menu.
Mapping – (Requires Option 352) opens a menu of softkeys that enables
the Indoor / Outdoor on–the–box mapping features. Refer to
"Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer
Mode (Option 233 on N991xA), and GPS Receiver (Option 307))."
Phased Array Antenna
softkeys that enables the PAA measurements. Refer to
Rapid Prototype Phased Array Antenna – Option 360."
EMF Antennas – opens a menu of softkeys that enables the triaxial antenna
feature, for use in EMF measurements. Refer to
– (Full Capability Requires EMF Option 358, and SA mode (Option 233
Mixed Analyzers))."
Freq Extnd – opens a menu of softkeys that enables frequency extender
feature, for use with OML heads. Refer to
Frequency Extender (Freq Extnd) Settings" on page
Chapter 15.
(PAA – Requires Option 360) - opens a menu of
"How to view and change the
Keysight N9927-90020 User's Guide
Chapter 16,
Chapter 14, "5G
Chapter 15, "USB Antennas
737.