More Gnss And Gps Settings - Keysight A Series User Manual

System Settings
System Configuration
— Ant: OK – antenna present and working.
— Ant: OPEN – antenna is not drawing DC bias current. This could occur when
— Ant: SHORT – antenna center pin has been shorted to ground. The internal

More GNSS and GPS settings

See also,
1. Press System 7 >
2. Then
3. Then choose from the following:
— Enable and disable the synchronization of the FieldFox internal clock to the
The GPS Sync setting has the same restrictions as the Date and Time
setting. Learn more in
—
—
—
—
Keysight N9927-90020 User's Guide
an active antenna is not connected properly or the antenna does not require
DC bias current. Antennas that do not require bias current can still provide
an accurate GPS reading.
bias circuitry is disabled for about one minute, then re-enabled. You can
also press GPS OFF, then
bias.
"GNSS and GPS Freq Ref Source Settings" on page
System Configuration
GNSS (GPS+) or
GPS UTC time standard.
"Date and Time" on page
— ON The FieldFox clock is synchronized and updated approximately
once every hour to the time of the GPS clock.
— OFF The FieldFox clock is NOT synchronized with GPS. When set to
OFF after Sync was ON, the date and time does NOT revert back to
the settings before the clock was synchronized.
Display ON OFF Enables or disables displaying Lat/Lon Format and
Elevation Units.
Lat/Lon Format Change the format of the GPS display on the FieldFox
screen. Choose from:
— ddd°mm' ss.sss"
— ddd°mm.mmmmm'
— ddd.ddddddd° decimal degrees
None Lat/Lon is not displayed.
Elevation Unit Choose from:
— m (Meters)
— Feet
— Inches
GPS Internal to quickly re-enable the antenna
GPS (depending on options) >
degrees, minutes, seconds (default setting)
degrees, minutes, fractional minutes
763.
GNSS Settings
750.
761