How To Perform Normalization - Keysight A Series User Manual

Reflection Mode (SA Models) - Option 320
Reflection Mode Settings

How to perform Normalization

To Port 1, connect a known device (usually an Open or Short) to which
reflection measurements are to be normalized.
— Press Trace 6
— Then
The yellow data trace displays the current measurement with trace math
applied. The math operation symbol [D/M] is displayed on the lower left corner
of the screen. Learn more about Trace Math in
page
Data interpolation is NOT supported. If the Resolution setting is changed
with Trace Math enabled, the FieldFox will disable the math operation.
Keysight N9927-90020 User's Guide
Normalize
700.
"All about Markers" on
539