Record Source; Rtsa Data Recording - Keysight A Series User Manual

RTSA (Real-Time Spectrum Analyzer) Mode—Option 350 (CPU2 Only)
Record/Playback (RTSA Option)

Record Source

For this discussion, it is important to understand Trace States. Learn more
in
Figure 10-8 FieldFox RTSA Mode: Data Flow and Record Playback Data Points

RTSA Data Recording:

Density Spectrum information is not recorded. Only the trace data is saved.
— Data is recorded at the trace state processing block.
— Data can be recorded from Traces 1,2,3, or 4 which includes the trace state
— Data is ALWAYS played back into the same trace number that was
Keysight N9927-90020 User's Guide
— Segment Count
recording will automatically pause. Press Pause/Resume or Record
to capture another N traces, or Stop to end recording. Default is
OFF, which is NO limit to the number of traces to be recorded.
When set, a counter appears in the lower-left corner which counts
UP to the specified number of recordings.
"Trace Display States (SA Mode)" on page
(Max Hold, Min Hold, and so forth).
recorded. If four traces were active during the recording, but only one trace
was recorded, then during Playback only that one recorded trace is visible.
Sets the number of traces to record, after which the
212.
293