Channel Number X-Axis Annotation; Change Channel Step Size (Optional); Reverse Swap - Keysight A Series User Manual

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
SA Mode Settings

Channel number X-axis annotation

— Dn indicates Downlink channels.
— Up (not shown) indicates Uplink channels
— (−) indicates that the lowest frequency in the channel (128) is at the left
— (+) indicates that the highest frequency in the channel (130) is at the right
— When Center Channel or Freq Span is specified, the X-axis shows the
— When Start or Stop Channel is specified, the X-axis shows the Start Freq

Change Channel Step Size (Optional)

This setting allows you to use the
number by the specified value. The
is valid. Learn how to make it valid in the section, see
Channel Number of the Measurement" on page
— Press Freq/Dist then More.
— Press
— Enter a step value using the numeric keypad, the

Reverse Swap

Available ONLY with Opt. 209 and while in Step sweep mode. Each press of the
softkey causes the Start and Stop frequencies to swap. The Start becomes the
Stop and vice versa. Learn more about Step versus FFT sweeps in
(Opt 238)" on page
— Press Freq/Dist then More.
— Then
170
edge of the screen.
edge of the screen.
Center Freq (Channel) and Frequency Span.
(Channel) and Stop Freq (Channel).
Channel Step
knob. Then press Enter.
210.

Reverse Swap

arrows to increment the channel
Channel Step softkey appears only when it
"How to change the
169.
Keysight N9927-90020 User's Guide
arrows, or the rotary
"FFT Gating