Cat (Cable And Antenna Test) Mode - Keysight N9912A User Manual

CAT (Cable and Antenna Test) Mode

CAT Mode is typically used to test an entire transmission system, from the
transmitter to the antenna. This process is sometimes referred to as Line Sweeping.
CAT Mode is similar to NA (Network Analyzer) Mode. Learn more in the
Supplemental Online Help:
http://na.support.keysight.com/fieldfox/help/FieldFox.htm
CAT Mode Distance to Fault measurements are discussed on page 30.
In this Chapter
Measurement Selection ........................................ 21
Quick Settings ....................................................... 22
Frequency Range .................................................. 22
Scale Settings ....................................................... 23
Averaging ............................................................. 23
Single/Continuous ................................................ 24
Resolution ............................................................. 24
Sweep Time........................................................... 25
Output Power ........................................................ 25
Interference Rejection .......................................... 25
Coupled Frequency ............................................... 26
Procedures
Return Loss Measurement.................................... 26
1-Port Cable Loss Measurement .......................... 27
2-Port Insertion Loss Measurement ..................... 28
Distance to Fault Measurements ......................... 30
See Also
All about Calibration ............................................. 52
Set Markers ......................................................... 147
Use Limit Lines .................................................... 156
Use Trace Math ................................................... 159
Making 75Ω (ohm) Measurements at the FieldFox Supplemental Online Help:
http://na.support.keysight.com/fieldfox/help/FieldFox.htm
20 FieldFox User's Guide