Usb And Lan Power Meter Settings; How To Select Power Meter Mode; How To Select A Sensor Type; Average / Peak - Keysight A Series User Manual

Power Meter (USB/LAN) Mode - Option 302

USB and LAN Power Meter Settings

Use an attenuator between the DUT and the power sensor when
measuring power levels that are higher than +20 dBm. The attenuator
value can be subtracted from the measurement using the Offset feature,
discussed in
A sequence of status lights are displayed on the base of the power sensor,
when the FieldFox is in Power Meter (LAN Sensor) mode.
— Green / Green blinking light indicates the power sensor's identification
— Amber light indicates Zeroing is being performed. And, blinks when a valid
— Red light indicates an error has occurred with the power sensor. Refer to
— No light indicates the FieldFox is not communicating with the power
USB and LAN Power Meter Settings
Select Power Meter Mode before making any setting in this section.

How to select Power Meter Mode

— Press Mode_.
— Then

How to select a Sensor Type

— Press Meas Setup 4.
— Then

Average / Peak

— Press Measure 1
— Then choose from the following:
546
"Relative and Offset Power Measurements" on page
indicator is communicating. After successful identification, the green LED
stops blinking. No indication when the operating speed is 10 Mbps or
during line isolation.
link activity is detected.
power sensor documentation.
sensor. This is the case when in Hold mode or when NOT in Power Meter
Mode.
Power Meter (USB
Sensor Type USB LAN
— Average Measures and reports the average of the power
measurements.
Sensor).
(Default = USB).
Keysight N9927-90020 User's Guide
550.