Step 6: Enable Data Logging And Playback The Results - Keysight A Series User Manual

5G Rapid Prototype Phased Array Antenna – Option 360
How to Set Up Phased Array Antenna Settings
2. Press

Step 6: Enable Data Logging and Playback the Results

Spectrum and Strip Chart information is not recorded. Only the Table and
Bar Chart data are saved. See
GPS must be enabled for the log results to include a GPS stamp or use
Preferences to enable the timestamp. Refer to
Features
— Log files contain cell results for different component carriers (CCs)
— Data results can be logged
— Data results can be saved to a *.CSV, DREC (Option 360 only), or *.KML file.
— User specifies how often results are stored.
Procedure
1. Press
Keysight N9927-90020 User's Guide
— Storage Device
Scale/Amptd then choose:
— Autoscale
— Unit dBm
— External Gain
— External Gain
including timestamps and/or distance stamps.
— Timestamps are included in log files with or without GPS.
— GPS must be enabled for log altitude results.
Refer to "To change Data Logging Configuration settings:" on page
— Time: Store results every "n" seconds
— Altitude: Store results every "n" meters. GPS must be enabled to
store results by altitude.
Trace 6 > Data Logging
the Record Settings, Record
— Record (Outdoor Logging) or
— Play (If you have previously stored data recordings.)
a. Outdoor Mapping only: To set the
— Meas Interval
— Interval Type
"How to Record a Data Log" on page
Chapter 30, "System Settings."
to view the Data Logging softkeys and set
Save/Recall, and Indoor Map Data
Record
Time or Distance
438.
438.
Logging.
Settings—choose:
431