Cat (Cable And Antenna Test) Mode - Keysight N9923A User Manual

Keysight N9923A Handheld Analyzer
User's Guide
5

CAT (Cable and Antenna Test) Mode

In this Chapter
"Measurement Selection" on page 77
"Quick Settings Table" on page 78
"Frequency Range" on page 79
"Scale Settings" on page 79
"Averaging" on page 80
"Smoothing" on page 81
"Single or Continuous Measure" on page 81
"Resolution (Number of Data Points)" on page 82
"Sweep Time" on page 82
"Output Power" on page 83
"Interference Rejection" on page 85
"Coupled Frequency" on page 84
CAT Mode is typically used to test an entire transmission system,
from the transmitter to the antenna. This process is sometimes
referred to as Line Sweeping.
CAT Mode is similar to NA (Network Analyzer) Mode. Learn more in
the Supplemental Online Help:
http://na.support.keysight.com/fieldfox/help/SupH
elp/FieldFox.htm
CAT Mode Distance to Fault measurements are discussed in
Chapter 6, "DTF (Distance to Fault) Measurements",
on page 89
.
75