Field Strength Measurements; How To Select And Edit Corrections For Field Strength Measurements - Keysight A Series User Manual

Channel Scanner (Option 312)
How to Set Up Channel Scanner
Figure 27-17 Yellow Trace with Cable and Antenna Corrections

Field Strength Measurements

Yellow Trace
the sum of the antenna correction and the cable correction (These corrections
are linearly interpolated). (Antenna = ON, Apply Corr = ON). Refer to
27-17 on page
For information, refer to
— Learn how to set Y-Axis Units on
— Use a Band Power marker to measure total power over a range of

How to select and edit corrections for Field Strength measurements

The Antenna and Cable correction data survives a Mode Preset and Preset.
All Correction ON/OFF states survive a Mode Preset, but NOT a Preset.
— Press Scale/Amptd.
— Then
— Then
— Then choose from the following:
644
- Corrected trace with antenna factor. This correction, includes
644.
"Trace Display States (SA Mode)" on page 212
frequencies. Learn how in
More
Corrections
—Apply Corrections Auto Disabled
all settings.
—RcvrSide Antenna Off / On
the receiver side.
—RcvrSide Cable Off / On
Receiver side.
Yellow trace:
Cable correction,
which is the sum
of the antenna
correction and
the cable
correction (These
corrections are
linearly
interpolated).
"How to Set Y-axis Units" on page
"Band/Interval Power Marker" on page 225
Use Auto and Disabled correction for
Edit/Recall an Antenna file to be used on
Edit/Recall a Cable file to be used on the
Keysight N9927-90020 User's Guide
Figure
172.