Supported Power Sensors; Switching Between Pulse Measurement Mode And Power Meter Mode - Keysight A Series User Manual

Pulse Measurements Mode – Option 330

Supported Power Sensors

USB and LAN Power Sensors
— "Best Practices For Making The Most Accurate Radar Pulse Measurements"
Supported Power Sensors
Pulse measurements are made using any of the Keysight X-Series USB and
LAN Peak Power Sensors.
Table 23-1 Pulse Measurement X-Series USB and LAN Power Sensors
USB Power Sensor Model Numbers
U2021XA
U2022XA
U2042XA
U2044XA
U2049XA
U2062XA
U2063XA
U2065XA
Zeroing of the U2020 X-Series USB Peak Power Sensors is performed
automatically at power up, every 5 seconds, and prior to measuring low level
signals.

Switching between Pulse Measurement Mode and Power Meter Mode

Keysight N9927-90020 User's Guide
a
https://www.keysight.com/us/en/assets/7018-03483/application-notes/5991
-0434.pdf
a. Learn more, refer to the User's Guide and Programming Guide for your USB or LAN
model power sensor.
a. LAN power sensors require FieldFoxes to have CPU2 installed.
NOT Supported - Using a single USB or LAN Peak Power Sensor and
switching between Power Meter Mode and Pulse Measurement Mode. Both
modes will attempt to program the sensor, which could cause one or both
modes to hang, or at least report inaccurate data.
Supported - Using one X-Series Average Power Sensor connected to the
top USB port for Power Meter Mode, and X-Series Peak Power Sensor
connected to the bottom USB port for Pulse Measurement Mode.
LAN Power Sensor Model Numbers
L2061XA
L2062XA
U2063XA
L2064XA
L2065XA
L2065XT
a
569