Lan Sensor Settings - Keysight A Series User Manual

Pulse Measurements Mode – Option 330
Supported Power Sensors

LAN Sensor Settings

The LAN Sensor settings enable you to
— Select your model of sensor
— Enter your Sensor I.D. via DNS serial number or IP address
Learn more, refer to
page
To access the LAN Sensor Settings:
— Press Meas Setup 4 >
Using the LAN Sensor Settings
— Press
— Press
— Press
— Press
The LED indicator will turn red indicating the following error when the
DHCP server is not detected: –310, "System error; The sensor could
not obtain a LAN configuration using DHCP. The sensor will
try to obtain IP address using AutoIP if enabled". For more
information on LAN instrument connectivity, refer to the Keysight IO
Libraries Suite Connectivity Guide.
Keysight N9927-90020 User's Guide
"Power Meter (USB/LAN) Mode - Option 302" on
541.
Sensor Name [U2049XA]
the drop down list.
Sensor ID – then choose
— DNS Ser num – Enter the DNS Serial Number's last 5 digits as a way
for the FieldFox to connect with your LAN power sensor.
— IP Address – Enter the IP address of your LAN power sensor as a way
for the FieldFox to connect with your LAN power sensor.
DNS Ser Num – to enter a DNS serial number's last 5 digits to enable
the FieldFox to identify a LAN power sensor. This softkey is inactive Sensor
I.D. is set to IP Address.
LAN IP Addrs Not Specified
FieldFox to identify a LAN power sensor. This softkey is inactive Sensor I.D.
is set to DNS Ser Num.
More > LAN Sensor Settings
– then select your LAN sensor model from
– to enter an IP address to enable the
571