Frequency Range; How To Set Frequency Range; Scale Settings; How To Set Scale - Keysight A Series User Manual

CAT (Cable and Antenna Test) Mode
CAT Mode Settings
— Press
— When finished changing ALL settings, press

Frequency Range

Set the range of frequencies over which you would like to make CAT Mode
measurements.
When the frequency range is changed after a calibration is performed, the cal
becomes interpolated. Learn more in

How to set Frequency Range

— Press Freq/Dist.
— Then choose from the following
— Follow each setting by entering a value using the numeric keypad,

Scale Settings

Adjust the Y-axis scale to see the relevant portions of the data trace. The Y-axis
is divided into 10 graticules.
This setting can be changed at any time without affecting calibration accuracy.

How to set Scale

— Press Scale / Amptd.
Keysight N9927-90020 User's Guide
— When finished changing a value, press
Dock Window to relocate the Settings table to a position relative to
the trace window. The Dock Window setting persists through a Preset.
Choose from the following:
— Full (Default setting) Only the Settings table is shown on the screen.
The trace window is temporarily not shown
— Left The Settings table is shown to the left of the trace window
— Bottom The Settings table is shown below the trace window
— Start and Stop frequencies - beginning and end of the sweep.
— Center and Span
frequencies (half on either side of center).
arrows , or the rotary knob.
— After using the keypad, select a multiplier key. Learn about multiplier
abbreviations in
— After using the arrows
amount of frequency increment is based on the current span and can
NOT be changed in CAT Mode.
Done
"Interpolation *" on page
frequencies – the center frequency and span of
Chapter 1, "Overview."
or the rotary knob, press Enter. The
Done Edit.
to save your settings
155.
63