Keysight A Series User Manual page 420

5G Rapid Prototype Phased Array Antenna – Option 360
How to Set Up Phased Array Antenna Settings
If after making the setting changes in the steps below, no data is
displayed, refer to
7. User markers to identify azimuth and elevations settings:
8. Enable the Data Logging settings:
420
— Clear Graphics
graphic from the screen.
"Troubleshooting" on page
Select Marker –choose:
— Marker 1 2 3 4 5 6
Delta, or Peak softkey is black to indicate the current setting of each
marker.
— Normal displays a marker.
— Delta displays a marker relative to another active marker.
— Peak displays a marker on the peak point of the displayed trace.
— More – choose.
— Marker Trace – You can set up to four traces.
— Marker Table – Enable or disable the marker table that displays the
current markers and their values.
Learn more about markers. Refer to the
Features.".
See also Figure 14-5 on page
— Press Trace 6 >
— Record
— Play (If you have previously stored data recordings.) or
— To set Data Logging—choose:
a. Outdoor Mapping only:
— Optional: Then
— Then Interval Type
— Then, if applicable
seconds.
Or
— Then, if applicable
miters.
— Then Back
If applicable, this clears the current displayed PNG
– You can set up to six markers. The OFF, Normal,
Chapter 29, "Data Analysis
410.
Data Logging then
(Outdoor Logging) or
Record Settings
Meas Interval > ON
> choose Time or Distance.
Time Interval
Distance Interval
Keysight N9927-90020 User's Guide
441.
then choose:
enter time interval in
enter distance interval in