Source Tracking Offset And Offset Reversal; How To Set Tracking Offset And Offset Reversal - Keysight A Series User Manual

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
SA Mode Settings
About Antenna and Cable files
— Cable files are saved and recalled from the Cables folder.
— Antenna files are saved and recalled from the Antenna folder.
— To DELETE Cable or Antenna files, use the Manage Files feature. Learn more
— If the folder does not already exist on a USB or SD card, it is created
— All Antenna and Cable files are saved and recalled as *.csv files, which
— The FieldFox can also read *.ANT (Antenna) files that were created from
— Cable and Antenna (*.csv or *.ANT) files canNOT be edited in Data Link
How to create a Cable file from an S21 (NA mode) or an Insertion Loss
(CAT mode) measurement
1. Measure the S21 or Insertion Loss of a cable. In NA mode, select either
2. Use Manage Folders to change the active folder to CABLES. Learn how in
3. While in NA mode, save the measurement as a *.csv file. Learn how in
4. In Channel Scanner or SA mode, select Corrections, then recall the *.csv

Source Tracking Offset and Offset Reversal

This feature requires:
— N991xA and N995xA FieldFox Combination Analyzers to have Options 209,
— N993xA and N996xA Spectrum Analyzers to have Options 209 and 220
Source offset tracking is used to offset the Source frequency from the Receiver
frequency by a fixed offset at every tune frequency. This feature is used when
the DUT contains a frequency translation device or mixer.

How to set Tracking Offset and Offset Reversal

1. On the Receiver unit, press Measure 1 >
2. Then choose one or both of the following:
180
in "Manage Files" on page
automatically before storing the file.
allows them to also be read by spreadsheet programs.
older Keysight Spectrum Analyzers.
software.
LogMag, Linear, or VSWR formats.
"Manage Folders" on page
"How to Save a File" on page
file for correction.
210, and 233
787.
789.
778.
Source
>
Keysight N9927-90020 User's Guide
Advanced