Keysight A Series User Manual page 179

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
SA Mode Settings
When the table edits are complete
1. Press
2. Press
3. Press Scale/Amptd >
4. Press
Optional:
— Press
—
Keysight N9927-90020 User's Guide
— Previous / Next Page
data.
— Add Row Add a blank Freq/Value pair to the table,
— Delete/Clear then:
— Delete Row
table.
— Clear All
table and resets header information to default settings.
Done to close the Antenna/Cable Editor.
Antenna Off On
Then choose your final measurement amplitude unit, under Scale/more. If
you selected either dB /m
should see this list of available Field Strength units
— dBµV/m == dB micro Volts per meter
— dBm/m^2 == dBm per meter squared
— V/m == volts per meter
— W/cm^2 == watts per cm squared
— W/m^2 == watts per meter squared
— dBµA/m == dB micro Amps per meter
— dBG == dB gauss
— dBpT == dB pico tesla
Back > Back > Save Antenna
the specified Storage Device. Enter a filename using the FieldFox labeler
(learn more in "How to use the FieldFox labeler " on page
about Antenna and Cable files below.
Recall Antenna
the specified Storage Device.
Storage Device Changes the device used to save or recall files. Choose
from Internal (default setting), USB (must be connected) or SD card. This is
a different setting from the Save/Recall Storage Device setting.
Quickly scrolls through pages of Freq/Value
Remove the selected Freq/Value pair from the
then Yes Remove all Freq/Value pairs from the
> On.
or dB S/m for the Antenna Factor unit, you
More Unit dBuV/m and choose from:
>
or Save Cable
or Recall Cable to load an Antenna or Cable file from
to save your changes to
781). Learn more
179