Keysight A Series User Manual page 495

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode
(Option 233 on N991xA), and GPS Receiver (Option 307))
How to Use Data Logging (Option 352)
— Then
— Then
Keysight N9927-90020 User's Guide
— Press Line Length
length of the line of bearing to extend it far enough to allow other
points to cross, indicating a possible emitter location.
— Press Accept Point
and returns to the previous menu.
Edit Points – Opens up menu of bearing point editing softkeys.
Choose from:
— Select Point – Enter the point you want to edit. Then you can directly
enter a new angle or line length or use the
knob to edit these values.
— Direction Line OFF ON
= OFF).
— Press Adjust Angle
Rotate the line about the current point (your current location) to point
towards the highest signal strength seen by your directional antenna.
You can rotate the knob to rotate the line, or you can type an angle
into the active entry directly.
— Press Line Length
length of the line of bearing to extend it far enough to allow other
points to cross, indicating a possible emitter location.
— Delete Point – deletes the currently selected point.
Clear Points – Deletes all of the displayed bearing points and lines.
– Enters a value for the line's length. Adjusts the
or Back – verifies the new point is to be added
– Enables/disables the direction line (default
– Enters the angle of the current point's line.
– Enters a value for the line's length. Adjusts the
arrows, or the rotary
495