Recording Configuration - Keysight A Series User Manual

Interference Analyzer (SA Mode) – Option 236
Record/Playback (SA Option)

Recording Configuration

To change Recording Configuration settings:
— Press Trace 6
— Then
— Then
— Then
Then choose from the following:
—
—
—
Keysight N9927-90020 User's Guide
— Record Playback Setup
Configuration settings or Close the session.
Record Playback
New Session or
If New Session is selected:
— Then Session Data
— Then CSV SaveStyle
——Single Trace
——Range Traces
selection requires you to manually select a range of traces to
be recorded in the Playback Configuration menu. Refer to
"Playback Configuration" on page
——AllTraces
— Then TraceRecordLimit
— Then Clear AllRecords
— Then Back to return to previous menu.
Recording Configuration
Record Time Sets the amount of time to record traces. Default is MAX,
which is to record indefinitely. Enter a value between 1s and 1 Ms (million)
seconds using the numeric keypad,
set, a timer appears during recording in the lower-left corner which counts
DOWN from the specified time.
Record Source Sets where, in the FieldFox data flow, data is recorded.
Learn more in "Record Source" on page
— RawMeas Records raw measurement data.
— Trace 1,2,3,4 Records data from the corresponding trace in its
current state.
Record Interval Sets the amount of time to wait between individual trace
recordings. Default is MIN, which is to wait 0 seconds (record traces as fast
as possible). Enter a value in seconds between 0 (no delay) and 10,000
seconds - about 3 hrs) using the numeric keypad,
knob.
Return to the setup menu to change
Recall an existing session.
and choose one of the following:
(default) saves the currently displayed trace.
saves the currently displayed trace. This
saves all traces.
to change the maximum recording file size.
to clear all traces out of memory.
arrows, or the rotary knob. When
527. Choose from the following:
528.
arrows, or the rotary
525