How To Record A Data Log Procedure; To Change Data Logging Configuration Settings - Keysight A Series User Manual

Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5GTF
Option 377 (CPU2 Only)
How to Use Data Logging (OTA Options 370, 372, and 377)
When GPS is enabled,
display. Learn more in
If Data Logging or Playback is not occurring when you think it should,
check the following:
— Is the sweep in HOLD? (upper-left annotation), or check the Sweep
— Is Recording or Playback Paused? (mid-left annotation)
— Is the Data Logging or Playback Interval set too long? (Configuration

How to Record a Data Log Procedure

Data Log-Play files are saved to:
—
—
— Press Trace 6 >
— Then for Outdoor Logging, press
During recording, choose from the following:
—
—
—
—

To change Data Logging Configuration settings:

1. Press Trace 6 >
2. Then choose from the following:
Keysight N9927-90020 User's Guide
GPS R
"GNSS (GPS+) and GPS" on page
menu for Continuous set to OFF.
settings.)
If File Folder is set to Default then Data Log-Play files are save-recalled
to:
"[CurrentDevice]\RecordPlayback\OTA
If File Folders are set to System, then Data Log-Play files are
save-recalled to:
"CurrentDevice\<UserSelectedFolder>\
More >
is displayed in the left of screen graticules.
Pause Resume Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue recording.
Stop Immediately stops recording. For more, refer to
FieldFox labeler " on page
Record Settings (Outdoor Mapping only) opens a softkey menu to enable
you change your record related settings. For more, refer to
Logging Configuration settings:" on page
Recall Save/Recall opens a softkey menu to enable you to save and recall
your data log and related file settings. For more, refer to
Logging Configuration settings:" on page
More >
is indicated at the bottom of the FieldFox
Data Logging >
Record
781.
393.
393.
Data Logging
758.
"
"How to use the
"To change Data
"To change Data
393