Cat (Cable And Antenna Test) Mode - Keysight N9913A User Manual

Keysight Handheld Analyzers
N99xxA User's Guide
3

CAT (Cable and Antenna Test) Mode

IMPORTANT! For CAT and NA modes, limit lines do not apply
where F1 = F2.
In this Chapter
"Measurement Selection" on page 45
"Quick Settings Table" on page 46
"Frequency Range" on page 47
"Scale Settings" on page 47
"Averaging" on page 48
"Smoothing" on page 49
"Single or Continuous Measure" on page 49
"Resolution (Number of Data Points)" on page 50
"Sweep Time" on page 50
"Output Power" on page 51
"Interference Rejection" on page 51
"Coupled Frequency" on page 52
CAT Mode is typically used to test an entire transmission system,
from the transmitter to the antenna. This process is sometimes
referred to as Line Sweeping.
CAT Mode is similar to NA (Network Analyzer) Mode. Learn more in
the Supplemental Online Help:
http://na.support.keysight.com/fieldfox/help/SupHelp/F
ieldFox.htm
CAT Mode Distance to Fault measurements are discussed in
Chapter 4, "DTF (Distance to Fault)
43
Measurements.".