How To Set Up Channel Scanner - Keysight A Series User Manual

Channel Scanner (Option 312)

How to Set Up Channel Scanner

How to Set Up Channel Scanner
This section briefly reviews the steps in setting up a channel scan
measurement. If you are not familiar with this process or would like more
information, refer to
1. Define some channels (refer to
2. Select
3. Modify scale and specify color bar coding—Modify the scale and assign
4. Enable Data Logging Settings: Press Measure 1 or Trace 6 >
Keysight N9927-90020 User's Guide
"How to Define a Channel and Use Channel
Scanner").
a. Select a Scan Mode—choose:
— Range Specify total channels, channel spacing or
— Custom List
b. Then modify channels based on the selected scan mode
Display Type—choose:
— Bar ChartV or
— Bar ChartH or
— Channel Pow or
— Strip Chart or
— Chart Overlay or
— Scan&Listen
colors to low and high power channels (bars):
Press Scale/Amptd
Then one of the following:
— Red Limit to set the power level and color scale for high power
channels.
— Blue Limit to set the power level and color scale for low power
channels.
— Others: Scale, Ref
to view the Data Logging softkeys and set the
Save/Recall, and Indoor Map Data
— Record (Outdoor Logging) or
— Play (If you have previously stored data recordings.) or
— View (Option 312 only)
a. To set the Record Settings
— Meas Interval
"How to Define a Channel and Use Channel
Specify a list of channels from an editor
Level, RF Atten, etcetera as desired.
Record
Logging.
(Outdoor Mapping only)—then choose:
Scanner".
Data Logging
Settings, Record
625