Top Panel - Keysight A Series User Manual

Preparing for Initial Use of Your New FieldFox
Take the FieldFox Tour

Top Panel

Caption Descriptions
Port 1 For CAT and NA measurements, use to make reflection measurements.
RF Output Maximum: ±50 VDC, +27 dBm RF
Also, for SA source output in SA mode.
Port 2 For SA, use to make all measurements.
SA RF Input
For CAT, NA, and VVM mode, use to make Port 2 transmission
measurements.
Maximum: ±50 VDC, +27 dBm RF.
GPS Ant SMA (f) connector for use with built-in GPS. Produces a 3.3 VDC bias
voltage for the antenna pre-amplifier. Use with a GPS antenna such as
N9910X-825. Other GPS antennas can also be used.
Ref In SMA (f) connector for use with Frequency Reference Source and External
Trig In Trigger Input signal.
Maximum: 5.5 VDC.
Keysight N9927-90020 User's Guide
Learn More:
"CAT Mode Settings"
on page 61
"NA Mode Settings" on
page 101
Chapter 9, "SA
(Spectrum Analyzer)
Mode (Option
233–Mixed Analyzers)",
on page 161
"SA Mode Settings" on
page 165
"GNSS (GPS+) and
GPS" on page 758
"Frequency Reference
Source" on page 763.
"Triggering" on
page 206
51