Keysight A Series User Manual page 244

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
How to Set Up EMF Settings (Requires EMF (Option 358), GPS (Option 307), and SA
Mode (Option 233–Mixed Analyzers))
244
— Triaxial XYZ
when a compatible triaxial antenna's factors have
been imported) for measuring channel
measurements and EMF.
— Then <Back to exit to the previous softkey menu.
e. Optional (Triaxial XYZ Antenna):
Verifying antenna and cable corrections are applied:
i. Press Scale/Amptd >
— Then verify the
softkey is set to Auto (This is the default setting when a
compatible USB antenna's correction factors have been
imported, via the System softkeys).
— Verify the
Antenna
disabled individually, but for EMF measurements all
three axes should be enabled (i.e., Antenna = Off, the
applications are setting the X/Y/Z).
— Verify
where an additional cable has not been connected to
the triaxial antenna. Before a cable can be used with
the EMF measurements it needs to have corrections
loaded. If you are going to use a cable, then choose as
needed:
ii. Optional: Press
(default, when Channel Power is on and
More > Corrections
Apply Corrections Auto Disabled
X axis Antenna, Y axis
are all ON. These can each be enabled or
Cable is ON. This can be disabled for applications
— Edit Cable displays a cable corrections table
that you can edit
— New displays a cable corrections table that
you can edit with new cable correction
content.
Yes
– Choose
Yes
data
No
– Choose
No
view
— Save Cable Opens a menu to name and save
the cable corrections data
— Recall Cable Recalls the selected cable
correction file from the \Cables folder.
— Storage Device to select the storage device
where your cable correction file is located
(Internal/USB/SD Card)
More then
Keysight N9927-90020 User's Guide
Antenna, and Z axis
to overwrite the current cable
to exit the cable data edit table