How To Change From Linear To Log Axis View; Radio Standard; How To Select A Radio Standard - Keysight A Series User Manual

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
SA Mode Settings
— Press Freq/Dist
— Then
— Then

How to change from Linear to Log Axis View

— Press Freq/Dist >
— Then choose from the following:

Radio Standard

A Radio Standard is a collection of settings that are applied to the FieldFox for
specific RF protocols. When a Radio Standard is applied, the FieldFox
frequency and channel settings change to that of the standard.
By default, the FieldFox locates the center frequency of the standard in the
middle of the screen and sets the frequency span to cover all of the Uplink and
Downlink frequencies. The selected Radio Standard name appears in the
center of the screen below the X-axis.
After a Radio Standard has been selected, the frequency range can be
changed by selecting channel numbers rather than frequency. Learn how in
"How to set Frequency Range" on page
When a Channel Measurement is selected such as ACPR, other relevant
settings will be changed such as Integration BW. Learn more about Radio
Standards and Channel Measurements in
Measurements" on page

How to select a Radio Standard

— Press Measure 1 OR Freq/Dist then
— Then
— Then
Keysight N9927-90020 User's Guide
More
CF Step Auto Manual
—Auto Each press of the
value by 1/10th (one division) of the current frequency span. Note: To
change this setting from Manual to Auto, press CF Step twice.
—Manual Type a step size value using the numeric keypad, then select a
multiplier key. Learn more in
More
— Log Freq AxisX enables/disables the log frequency X-axis. Disabling
the log frequency X-axis, enables the linear frequency X-axis (Default
= OFF).
— Full Span Selects the entire frequency span of the FieldFox. The
Center frequency is set automatically.
229.

Radio Standard

Radio Standard
arrows increments or decrements the
"Multiplier Abbreviations" on page
165.
"Radio Standards and Channel
More
56.
167