How To Use Dut Measurement Setups; Using Measure Setup To Choose Dut Type - Keysight A Series User Manual

Noise Figure Mode (Option 356 – CPU2 Only)
How to Define a Noise Figure Measurement

How to Use DUT Measurement Setups

Noise figure Option 356 has four predefined measurement setups:
— Amplifier
— Downconverter
— Upconverter
— Multi-Stage Converter
Refer to
Each of the four measurements has frequency context and loss compensation
softkeys that can used to optimize the DUT's noise figure measurement. Refer
to
Compensation" on page

Using Measure Setup to Choose DUT Type

This section contains the following:
— Setting
— Setting
— Setting
— Setting
664
— Uncert Cover
current settings.
Then choose:
— Uncert Bars
uncertainty bars values for the current settings.
— Back
"Using Measure Setup to Choose DUT Type" on page
"DUT Type and Frequency Context" on page 669
DUT > Type [Amplifier], see
DUT > Type [Downconverter], see
DUT > Type [Upconverter], see
DUT > Type [Multi-Stage
——User Cal Uncert. Enable/disable the User Cal
Uncertainty.
——Back to return to previous menu.
Sets the uncertainty coverage value for the
σ σ
1 , 2 (default), or
Enables/disables the uncertainty calculator
to return to previous menu.
674.
Figure 30-1 on page 665
Figure 30-2 on page 666
Figure 30-3 on page 667
Converter], see
Keysight N9927-90020 User's Guide
σ
3 .
664.
and to "DUT Type Loss
Figure 30-4 on page 668