Cat (Cable And Antenna Test) Mode - Keysight N9912A User Manual

Keysight Handheld Analyzers
N9912A User's Guide
3

CAT (Cable and Antenna Test) Mode

In this Chapter
"Measurement Selection" on page 3-3
"Quick Settings Table" on page 3-4
"Frequency Range" on page 3-5
"Scale Settings" on page 3-5
"Averaging" on page 3-6
"Smoothing" on page 3-7
"Single or Continuous Measure" on page 3-7
"Resolution (Number of Data Points)" on page 3-8
"Sweep Time" on page 3-8
"Output Power" on page 3-9
"Interference Rejection" on page 3-10
"Coupled Frequency" on page 3-11
CAT Mode is typically used to test an entire transmission system,
from the transmitter to the antenna. This process is sometimes
referred to as Line Sweeping.
CAT Mode is similar to NA (Network Analyzer) Mode. Learn more in
the Supplemental Online Help:
http://na.support.keysight.com/fieldfox/help/SupHelp/F
ieldFox.htm
CAT Mode Distance to Fault measurements are discussed in
Chapter 4, "DTF (Distance to Fault)
3- 1
Measurements.".