Cat/Na - Keysight A Series User Manual

System Settings
Preferences
3. Then

CAT/NA

Choose the CAT/NA settings for SnP file save, default factory error corrections,
extended cal default. See also
included in saved SNP Data:" on page
How to select CAT/NA defaults:
1. Press System 7 >
2. Then use arrow softkeys or the knob to select CAT/NA
3. Then Edit for each of the following:
4. Then
SA
Choose the SA setting for Individual measurement Control default. See also
"Alignments" on page
How to select SA defaults:
1. Press System 7 >
2. Then use arrow softkeys or the knob to select SA
3. Then
Keysight N9927-90020 User's Guide
— Cable (default and the most accurate)
— Auto
Done Edit (after each change in setting)
Preferences
— SnP File Save
— Default
— Advanced
— Default Factory Error Corr. (N995xA/6xA Only)
— Enhanced Response
— Full 2 Port
— Extended Cal Default (N995xA/6xA Only)
— On
— Off (default on models >6 GHz)
Done Edit (after each change in setting)
215.
Preferences
Edit for each of the following:
— Individual measurement Control
— On (Default - recommended)
— Off
— ADC Over Range Warn Emphasis
"> What Data Processing functions are
787.
Preferences
>
Preferences
>
755