How To Add Directional Finding (Df) Bearing - Keysight A Series User Manual

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode
(Option 233 on N991xA), and GPS Receiver (Option 307))
How to Use Data Logging (Option 352)

How to Add Directional Finding (DF) Bearing

IMPORTANT! You must be in Channel Scanner Mode to use this feature.
DF Bearing adds angles and horizontal lines between the direction of an object
(point) and another object. Refer to
16-24 on page
See also,
page
— Press Mode >
— Press Measure 1 >
— Optional (Ignore for Outdoor Mapping): Press
IMPORTANT!
When you recall a *.kdat file, you are able to add mapping points, but you
will only be able to save the changes as a *.png. file. Optionally, if you save
a file as a *.png file and then recall the file, you can add data points and
save the changes as a *.kdat file.
Indoor and Outdoor Data Logging
— Then
— Then
494
497.
"Downloading and Using the FieldFox Map Support Tool" on
462.
More (Depending on installed options, may not be
necessary.) > Channel Scanner
Data Logging
then choose:
— Press Record Indoor Data
or
— Press Recall Indoor Log
(*.kdat)). You can recall a log file and add/delete directional finding
lines of bearing and map data to previously saved files. Re-save them
and resume data collection at a later time.
Signal Locate
Add Point – adds a new bearing location then:
— Press Direction Line OFF ON
(default = OFF).
— Press Adjust Angle
Rotate the line about the current point (your current location) to point
towards the highest signal strength seen by your directional antenna.
You can rotate the knob to rotate the line, or you can type an angle
into the active entry directly.
Figure 16-23 on page 496
> More
Indoor Map Data Logging
– by selecting previously stored *.png file
File– (if you have previously stored data
– Enables/disables the line of bearing
– Enters the angle of the current point's line.
Keysight N9927-90020 User's Guide
and Figure