Keysight A Series User Manual page 450

USB Antennas – (Full Capability Requires EMF Option 358, and SA mode (Option 233
Mixed Analyzers))
How to Set Up a USB Antenna (Also, Known as EMF Antenna)
If the antenna factor import is successful, the FieldFox displays:
"Success: Antenna Factors Imported: Tri-Ax Antenna ID:
->[R] Antenna ID: SDIA-6000-1006 ->[]". The last 4-digits will vary
for each antenna (i.e., "1006" is changeable).
If the FieldFox displays this error Error: USB antenna Error: Not
found or Unable to communicate with antenna. Ensure it is
connected. is displayed, verify the USB antenna is connected correctly.
Refer to
4. If you have not selected a mode and set up your measurement, then do so
5. Enabling the imported USB antenna factors and Cable factors:
6. If you need to edit or add new antenna factors or cable factors, then
7. Once you have finished with your USB antenna setup:
450
— Then Import Antenna
antenna connected to the FieldFox.
"Troubleshooting" on page
— Then EMF Antenna [Tri Axial]
Manual). Only compatible USB triaxial antennas can be used for
EMF measurements.
— Optional: Press
FieldFox determines the X/Y/Z settings for the current
measurement. Alternately, you can select either X, Y, or Z to enable
and to edit a position manually (i.e., an example of editing X, Y, and
Z axes is covered in step 5).
now. Refer to step 1.
Choose one of these:
— SA Mode: "How to Set Up EMF Settings (Requires EMF (Option 358),
GPS (Option 307), and SA Mode (Option 233–Mixed Analyzers))" on
page 239.
— OTA Mode: "How to Set Up EMF Settings (Requires EMF (Option
358))" on page 385.
repeat step 5 as required for Y, Z, and the Cable Factors. See also,
Set Up EMF Settings (Requires EMF (Option 358), GPS (Option 307), and
SA Mode (Option 233–Mixed Analyzers))" on page 239
EMF Settings (Requires EMF (Option 358))" on page
a. Press Sweep 3 >
The FieldFox should display in order Analyzing CCO X-Axis,
Analyzing CCO Y-Axis, and Analyzing CCO X-Axis and then
do a square root sum of the X, Y, and Z measurement values in the
FieldFox. Multi-cell measurements are done similarly for each cell
ID (i.e., Cell CC0 to CCn). Refer to
– to import the antenna factors from the USB
454.
verify Tri-Axial is selected (Default ==
Antenna Axis with Auto (default) selected the
Single Restart
>
Figure 15-4 on page
Keysight N9927-90020 User's Guide
"How to
and "How to Set Up
385.
451.