Keysight A Series User Manual page 474

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode
(Option 233 on N991xA), and GPS Receiver (Option 307))
How to Set Up Mapping Settings
If a "Error: This data point not ready..." is displayed, verify
antenna setup.
A KDAT file is the file FieldFox uses to recall an indoor mapping/data
logging session ("Recall Indoor Log File"). It's an archive file that contains
information about the original image file, the location of the recorded data
on the image and the actual recorded data. KDAT files can only be opened
with FieldFox itself. KDAT files cannot be opened via Data Link.
An auxiliary CSV data file is generated automatically, each time a KDAT file
is saved during an indoor mapping session. The CSV contains the recorded
data, without the image, location of the recorded data, etcetera.
474
a. The Scroll to indoor floor plan *.png file
b. Press Recall File- enables you to recall previously stored *.kdat file
that you can view or modify.
c. Move the position cursor to current location:
— Then press Pan
move the position cursor to current location and mark data
points, using East, West, North, and
— Or you can use the
numeric keypad locate the position cursor to current location.
d. Then press Record Data
enter a new data point.
e. Repeat step c and
Else, continue to next step.
f. When done, press
> Save Map to save results to a *.KDAT file.
to open a menu of softkey to enable you to
arrows, the rotary knob, or
when data pointer is in desired position to
d for all other required position locations.
Back (If you used the Pan softkey menu) >
Keysight N9927-90020 User's Guide
South softkeys.
More