Keysight A Series User Manual page 365

Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5GTF
Option 377 (CPU2 Only)
How to Set Up Over–the–Air (OTA) Mode Settings
If after making the setting changes in this section, no data is displayed,
refer to
Display does not update (refresh), until all active component carriers (CCs)
have been scanned.
12. Enable the
Spectrum and Strip Chart information is not recorded. Only the Table and
Bar Chart data are saved. See
page
Data Log-Play files are saved to:
Keysight N9927-90020 User's Guide
error is greater than 900 Hz, no data is displayed. 5GTF: Default =
1%, i.e., if a carrier signal's sync correlation is smaller than 1%, no
data is displayed).
"Troubleshooting" on page
Data Logging
— Press Trace 6 > More
Logging to view the Data Logging softkeys and set the
Settings, Record Save/Recall, and
— To set Record Playback—choose:
— Record (Outdoor Logging) or
— Play (If you have previously stored data recordings.)
393.
If File Folder is set to Default then Data Log-Play files are
—
save-recalled to:
"[CurrentDevice]\RecordPlayback\OTA"
— If File Folders are set to System, then Data Log-Play files are
save-recalled to: "CurrentDevice\<UserSelectedFolder>\
a. To set the Record Settings
— Then Meas Interval
— Then Interval Type
— Then, if applicable
seconds.
Or
— Then, if applicable
miters.
— Then Back
401.
settings:
(All Modes) > More (5G NR only) then
Indoor Map Data Logging
"How to Record a Data Log Procedure" on
(Outdoor Mapping only) —then choose:
> ON
> choose Time or Distance.
Time Interval enter time interval in
Distance Interval
Data
Record
enter distance interval in
365