How To Set Battery Saver; Startup Mode; How To Setup Startup Mode; Display - Keysight A Series User Manual

System Settings
Preferences

How to set Battery Saver

1. Press System 7 >
2. Then scroll to Global Settings > Battery Saver

Startup Mode

The Startup Mode setting determines the mode that becomes active (visible)
when User Preset is set to OFF (Factory Preset) and the FieldFox is powered
ON. See

How to setup Startup Mode

1. Press System 7 >
2. Then scroll to Global Settings > Startup Mode and press Edit.
3. Then repeatedly press the

Display

Choose the Display values (Display Colors, Trace Width, Brightness, Title
Enabled, Title). See
How to select Display values:
1. Press System 7 >
2. Then use arrow softkeys (
3. Then
748
Preferences
— ON – To conserve battery power, the RF source power is turned OFF
at the end of each CAT, NA, and VVM mode sweep. This behavior
does not impact FieldFox measurements.
— OFF – Source power is kept ON at all times, including during trigger
Hold mode and between single sweep acquisitions. The RF source
stays at the stop frequency until another sweep begins.
This provides a constant, uninterrupted RF output from the RF OUT
port. This behavior also provides the highest trace stability
sweep-to-sweep which may only be evident while using either
single sweep or Run/Hold. With Battery Saver OFF, the use of a full
battery charge is reduced by approximately 45 minutes.
"User Preset" on page
Preferences
choices.
— <Default> is the factory default mode for your FieldFox model.
— Built-in Power Meter Mode is NOT allowed as a Startup Mode.
"Display (Settings)" on page
Preferences
Edit for each of the following:
— Display Colors
— Indoor (default)
Preferences
>
732.
Preferences
>
Startup Mode to scroll through the available
733.
Preferences
>
) or the knob to select Display
Keysight N9927-90020 User's Guide