How To Use Data Logging (Option 352); Screen Annotation - Keysight A Series User Manual

Hide thumbs Also See for A Series:

Table of Contents

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode

(Option 233 on N991xA), and GPS Receiver (Option 307))

How to Use Data Logging (Option 352)

Data Log-Play files are saved to:

Data Logging allows you to GPS mapping data and play them back at a later

time. Use this feature to overlay Maps pointers on your indoor or outdoor files.

Data logs can be saved to the FieldFox Internal memory, an SD Card, or a USB

flash drive.

This section assumes you have already completed the initial setup and have a

measurement setup in the FieldFox.

This section contains the following sections:

During a record or playback session, the following is displayed in the

top-center area of the screen:

— The name of a recording can be changed using Manage Sessions. Learn

When GPS is enabled,

display. Learn more, see the FieldFox User's Guide's "System Settings"

The Mapping mode can display and be recorded/played back in field strength

units, when the units are changed:

If File Folder is set to Default then Record-Play files are save-recalled

[CurrentDevice]\RecordPlayback\[Current mode]\

If File Folders are set to System, then Record-Play files are

save-recalled to: "

CurrentDevice\<UserSelectedFolder>\"

"Screen Annotation" on page 492

"How to Add Directional Finding (DF) Bearing" on page 494

"How to Record a Data Log (Outdoor Logging Only)" on page 497

"To change Data Logging Configuration settings:" on page 498

"How to Play a Data Log" on page 498

Rec: 55/55 2018-12-31 03:26:11 PM

is the current and total trace number: currently trace is 55 of 55 total

2018-12-3103:26:11 PM

Table of Contents