How To Set Up A Usb Antenna (Also, Known As Emf Antenna); Usb Antenna Setup Procedure - Keysight A Series User Manual

USB Antennas – (Full Capability Requires EMF Option 358, and SA mode (Option 233
Mixed Analyzers))

How to Set Up a USB Antenna (Also, Known as EMF Antenna)

How to Set Up a USB Antenna (Also, Known as EMF Antenna)
IMPORTANT! See also,
"SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers),"
Chapter 10, "RTSA (Real-Time Spectrum Analyzer) Mode—Option 350
(CPU2 Only)"
This section reviews some general high level steps in setting up a USB antenna
measurement. If you are not familiar with this process or would like more
information on specific EMF measurement setups, refer to:
— SA Mode:
— OTA Mode:

USB Antenna Setup Procedure

1. Select the mode and set up your measurement. Refer to
If necessary, this step can be skipped and done after the USB antenna is
set up.
2. Connect a USB antenna. Refer to
Only Agos Advanced Technologies SDIA–6000 Triaxial Lsotropic USB
antenna is compatible with EMF (Option 358). See also
(Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)"
"Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option
371, 5GTF Option 377 (CPU2
3. Importing and selecting the X/Y/Z antenna factors:
Keysight N9927-90020 User's Guide
"Alignments" on page
mode.
"How to Set Up EMF Settings (Requires EMF (Option 358), GPS
(Option 307), and SA Mode (Option 233–Mixed Analyzers))" on page 239
"How to Set Up EMF Settings (Requires EMF (Option 358))" on
page 385
"Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option
371, 5GTF Option 377 (CPU2 Only)"
Analyzer) Mode (Option 233–Mixed
a. OTA – 5G NR and SA Mode:
Press System > Utilities
215, in NA
or to Chapter 9, "SA (Spectrum
Analyzers)".
Figure 15-1.
Only)".
EMF Antennas
> >
mode,Chapter 9,
and
Chapter 13,
Chapter 9, "SA
and Chapter 13,
449