Enabling And Setting Up Indoor Map Logging - Keysight A Series User Manual

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode
(Option 233 on N991xA), and GPS Receiver (Option 307))
How to Set Up Mapping Settings
Record-Play files are saved to:
—
—
Learn more about file settings, refer to

Enabling and Setting Up Indoor Map Logging

1. Press Measure 1 >
2. Press
IMPORTANT!
When you recall a *.kdat file, you are able to add mapping points, but you
will only be able to save the changes as a *.png. file. Optionally, if you save
a file as a *.png file and then recall the file, you can add data points and
save the changes as a *.kdat file.
Keysight N9927-90020 User's Guide
——
If File Folder is set to Default then Record-Play files are save-recalled
to:
"[CurrentDevice]\RecordPlayback\[Current mode]\"
If File Folders are set to System, then Record-Play files are
save-recalled to:
"CurrentDevice\<UserSelectedFolder>\
Data Logging
Indoor Map Data Logging
— Record Indoor Data
— Recall Indoor Log File
You can recall a log file and add/delete directional finding lines of
bearing and map data to previously saved files. Re-save them and
resume data collection at a later time.
After a *.png is opened for a new recording or a *.kdat file is recalled
for editing and displayed on the FieldFox, then choose from the
following:
Sets the type of icon that is used to display a
Icons
map's data points (default = Flag).
Flag Point
Line
Save Image (PNG) Saves the current displayed
map to a *.png file (default filename is
"MapImageFile"). This softkey is available (active)
when View Maps = ON.
Chapter 32, "File Management."
> More
— then choose:
– by selecting a previously stored *.png file or
(if you have previously stored data (*.kdat)).
487