Keysight A Series User Manual page 360

Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5GTF
Option 377 (CPU2 Only)
How to Set Up Over–the–Air (OTA) Mode Settings
6. Optional (Option 370 LTE FDD and Option 371 LTE TDD Only): Press
Band and Channel values vary between LTE FDD and LTE TDD.
7. Select Trace 6—choose:
360
— Then Center – You can enter a frequency or for LTE FDD/LTE TDD
(only), you can use the Channel Table softkey menu to enter an
auto-coupled Center frequency (see LTE FDD and LTE TDD Channel
Table softkey menu below).
Freq/Dist > Freq Mode
This changes the Center frequency value.
Press Channel Table opens a softkey menu, where you can select define
your carrier, by Band and Channel. The Center frequency value is
auto-coupled to the Band/Channel entered.
Option 370 LTE FDD and Option 371 LTE TDD Only:
— Then Band > n >
(The Channel, Band, and the
— Then Favorites List
Only) opens a softkey menu, where you can save your current Band
and Channel setup.
— Then Setup 1
softkey displays the current Band and Channel displayed
(e.g., Setup 1
again to observe the updated Setup 1 softkey.
— Then Back
— Window 1 2 3 4
— Then Win State OFF ON
— Then Display Type
— Table or
— Bar Chart
— Spectrum
> Chan
Enter
Center values are auto-coupled.)
(Option 370 LTE FDD and Option 371 LTE TDD
In the Favorites list softkey menu, the
3,1200). Select the Favorites List softkey
to ON
or
or
Keysight N9927-90020 User's Guide