Keysight A Series User Manual page 740

System Settings
Utilities
7. Optional: Press
8. Press Mode > and then your preferred mode for testing.
IMPORTANT! The softkey menu for editing of the frequency converter
correction files is only available when the FieldFox is in SA mode.
It is important to save any changes that are made to the Settings table. If
the Setup Corr softkey is reset to Auto, it will recall the last
"...Default.csv" used, and any unsaved changes will be lost.
740
Apply Corr ON OFF
nominal file corrections. Press to apply corrections for the Converter, all
supported modes will apply corrections and annotate "eCorr" in the left
panel. The corrections applied (regardless of mode) are either
default/nominal (if Auto loading was used) or custom/specific (if manual
editing Edit SA was used). Default is OFF.
— Optional: If you pressed
and to edit a "*.csv" corrections file then:
— Press Scale/Amptd >
Converter
OFF is selected to not apply the default
Edit SA in step
More
>
then:
a. Converter to enable/disable the frequency
converter corrections.
b. Edit Converter to opens a corrections table of the
currently selected file (*.csv).
To select a setting/value to edit, use the numeric
keypad, arrows, or rotary knob to change
the value.
Refer to Figure 30-4 on page
c. New to opens a corrections table of the currently
selected file (*.csv), but enables you to create a
new converter corrections file. Displays
"Overwrite existing Converter data?"
Then choose:
——Yes to clear all of the frequency
converter correction table's values and
enter your own.
——No to leave the current correction table
values and edit just some of the entries.
To select a setting/value to edit, use the numeric
keypad, arrows, or rotary knob to change
the value.
Keysight N9927-90020 User's Guide
6 above and want to display
Corrections OML
>
743.