Step 3. Define The Measurement - Keysight A Series User Manual

5G Rapid Prototype Phased Array Antenna – Option 360
How to Set Up Phased Array Antenna Settings

Step 3. Define the measurement

1. Press Preset then
2. Selecting Phased Array Antenna mode: Press
3. Optimizing the FieldFox to scan for signals:
428
1. In the Setting screen, use the
numeric keypad to highlight Obtain IP.
2. Press Obtain IP Static
3. Press Clear, then set the Static IP Address to: 192.168.1.2
and
4. Press Done
5. Press Clear, then set the Static Subnet Mask to:
255.255.255.0
and
6. Press Done
7. Press Clear, then set the Static Gateway to: 192.168.1.254
and
8. Press Done
9. Using the
select Apply Settings.
10. Press Edit, then select Now.
11. Press Done Edit
Mode Preset (Factory)
Antenna. Depending on the number of options loaded on your FieldFox, it
may be necessary to press More.
a. Run the Antenna Wizard: Measure >
prompts.
b. Set the Measure
ANT).
See also "How to Set Up Phased Array Antenna Settings" on
page 415.
c. Set the Meas Setup >
— Ball Antenna: LAN address
— Settings: Res BW, Video BW, and Beam Width
arrows, the rotary knob, or numeric keypad to
> Done
Antenna Wizard
type (i.e., Bore-Sight, Heat Map, Polar ANT, or Park
Antenna Settings
Keysight N9927-90020 User's Guide
arrows, the rotary knob, or
Mode > Phased Array
and follow the
table: